Dirt Bike Helmet Sizing Chart: How to Measure and Fit Your Helmet
Use this dirt bike helmet sizing chart guide to measure your head, compare brand sizes and check fit so your motocross or trail helmet stays snug and safe.
Updated November 2026
A dirt bike helmet sizing chart tells you which helmet size to try, but the chart alone does not guarantee a safe fit. You will learn how to measure your head, read a brand’s size table, and check that a helmet sits correctly before you ride. Each brand sizes differently, so the measurement is your starting point, not the final answer.
Step 1: Measure Your Head Circumference
Wrap a soft tape measure around your head about one inch above your eyebrows and ears, keeping it level all the way around. Pull it snug but not tight, and read the measurement in centimeters or inches. Write down the number and repeat the measurement once more to confirm it.
Shopping for one? See our guide: 9 Best Childrens Dirt Bike Helmets (2026): Expert Picks.
Step 2: Match Your Measurement to the Brand Chart
Every manufacturer publishes its own chart, and sizes do not carry over between brands. A medium from one maker may fit like a large from another. Use the chart from the specific brand and model you are considering, and find the range that contains your measurement. If you land between two sizes, the smaller one is usually the better starting point, because helmet padding compresses slightly with wear.
| Size | Typical head circumference (manufacturer ranges vary) |
|---|---|
| Youth S | Roughly 50–52 cm |
| Adult S | Roughly 54–55 cm |
| Adult M | Roughly 56–57 cm |
| Adult L | Roughly 58–59 cm |
| Adult XL | Roughly 60–61 cm |
These ranges are illustrative only. Always defer to the chart printed by the brand you are buying.
Step 3: Check the Fit Once the Helmet Arrives
A correct chart reading still needs a physical check. Put the helmet on with the chin strap fastened and confirm the following:
- The helmet sits level, with the front edge about one finger-width above your eyebrows.
- Cheek pads press evenly on both sides without pinching.
- You can move the helmet side to side with your hands, but it does not shift freely on your head.
- When you open your mouth wide, the cheek pads stay in contact with your face.
- The chin strap lets you fit one or two fingers under it, not more.
If the helmet rocks forward, back or sideways, try the next size down before accepting a loose fit. A loose helmet can move during a crash and reduce protection.
Fit Considerations for Riders Who Wear Goggles or Glasses
Off-road riding often involves goggles, and goggle strap placement affects how the helmet feels. Try the helmet with your goggles in place, since some riders find that a snug helmet pushes goggles into their face. Glasses wearers should also check that temples do not create pressure points under the cheek pads.
Common Mistakes
- Measuring over a hat or hair volume that changes the reading.
- Assuming your size carries over from a helmet made by another brand.
- Choosing a larger size to allow room for growth on an adult helmet.
- Skipping the fit check and relying only on the chart.
- Ignoring the helmet’s age and damage history when reusing a helmet.
Recommended Gear
A flexible tape measure marked in both inches and centimeters makes accurate head measurements much easier. View on Amazon
Motocross goggles with an adjustable strap can help you test how your eyewear sits with the helmet on before you ride. View on Amazon
FAQ
Should I measure my head with or without a helmet liner?
Measure your bare head, without a beanie or sweat liner, for the most accurate reading. Thick headwear can make the measurement look larger than your true head size.
Can I use a bike helmet size chart for a dirt bike helmet?
Not reliably. Off-road helmets often have different shell shapes and padding, so use the chart from the dirt bike helmet brand you plan to buy.
How do I know if a dirt bike helmet is too big?
If it shifts when you shake your head or the cheek pads do not stay in contact, it is probably too big. Consult a qualified fitter or the manufacturer if you remain unsure.
Conclusion
Measure your head, match the number to the brand’s own chart, and then test the fit with the chin strap fastened. A helmet that stays level, snug and stable is the goal. When in doubt, consult a professional fitter at a motocross shop before you ride.
Related reading
- Vintage Dirt Bike Helmet Picks: 7 Best Options for Riders in 2026
- Trek Tyro Youth Bike Helmet: Fit, Sizing and Safety Tips for Kids
- Spider Man Dirt Bike Helmet: 3 Best Picks for Kids and Young Riders
Ready to choose one?
